7.62x39

7.62x39

Showing all 3 results

  • RAIL ALIGNMENT FIXTURE

    Rail alignment fixture to install the lower bolt guide rails in 1mm receivers. The rails clamp inside the fixture which inserts into the trunnion to keep the rails even with the trunnion.

    The main body of the fixture goes in the receiver first and is bolted to the receiver and trunnion. Then the rails are clamped in the front with the screw and clamp. Be sure to push the rails in so they touch the back of the front trunnion.  The rear most section of the rails need to be leveled with the top rail from front to back by measuring down from the top rail then c-clamped in place. Then a weld on the front and rear of each rail is made to hold them in place so the fixture can be removed to finish all welds on the rails.

    Category: Tags: , , Product ID: 2123
    $25.00
  • 16 INCH CHROME LINED BARREL 7.62 X 39

    Made from 4150 Chrome Moly steel and ” Chrome Lined ” , Gas Port not drilled, outer suface in the white.

    These are made to fit the Romanian, Polish Underfolder, Egyptian Maadi parts kits as well as other standard 7.62 kits.  Will not work with Yugo M70’s.

    Marked 7.62 USA

    Category: Tags: , , , Product ID: 2051
    $150.00
  • POLISH AK47 80% BENT RECEIVER

    one of the best things from poland since the sausage,and this one wont give you heart burn!Just because this was made in Poland doesn’t mean it will only work with a Polish AK kit.  This beauty will work with any AK47 1mm stamped parts kit as long as the correct holes are drilled.  You can make it a Romanian fixed stock, Polish Underfolder, Romanian Underfolder, Kyber Pass, Maadi, AMD65, AMD63, M92 or anything that has a 7.62 magwell on a 1mm receiver.

    Category: Tags: , , Product ID: 1766
    $45.00
Minimum 4 characters